How close to the saw blade should the nozzles be for the atomized oil spray? How many pulses per/minute are recommended?

View previous topic View next topic Go down

How close to the saw blade should the nozzles be for the atomized oil spray? How many pulses per/minute are recommended?

Post by Granco Clark on Tue Apr 25, 2017 10:14 pm

How close to the saw blade should the nozzles be for the atomized oil spray? How many pulses per/minute are recommended?
avatar
Granco Clark
Admin

Posts : 5
Join date : 2017-04-25

View user profile http://www.grancoclark.com

Back to top Go down

EXTRUSION SAW LUBRICATION GUIDE

Post by Granco Clark on Tue Apr 25, 2017 10:15 pm

EXTRUSION SAW LUBRICATION GUIDE

1. Saw Blade Lube: Use “COOLUBE 2200”, available from:

GRANCO CLARK INC.
Parts Department
7298 N. Storey Road
Belding, MI 48809
(616) 794-2600

Pump should be set at 12 cycles per minute, meter should be set at .5 drops per cycle (open maximum clockwise, then back 20 clicks)

 This setting will give approximately 6 drops per minute.

2. Saw Slide: Use Lithium soap base grease No. 2.
Grease four bearing units monthly.

3. Hydraulic Unit: Check oil level weekly and refill if required.

4. Pneumatic Lubricator: Check oil level daily and refill if required.

5. Roller Drive: See vendor requirements from gear reducers.
Manually oil chain drives weekly.

Contact Service at:
+1-800-918-2600
customerservice@grancoclark.com
avatar
Granco Clark
Admin

Posts : 5
Join date : 2017-04-25

View user profile http://www.grancoclark.com

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum